DPCAV
POWER SUPPLY FILTER, L-C TYPE
This filter is used to reduce ripple noise and similar power supply nuisances. When used with power sources that have RFI/EMI noise problems we recommend that you also add Toroids filters on all the affected wires / cables. We offer popular sized Toroid (Ferrite) core filters that are ideal for RFI/EMI problems:Click Me!, Design Update: Beginning with September 2011 production, all PSF-001 filters are compatible with up to 5S LiPo batteries. Earlier production was limited to 3S applications. If you need to identify which voltage rating you have then check the printed voltage on the large 1000uF cap (capacitor); The older design used 16V caps where as the new design we now sell uses 25V rated caps., Note: Installations with severe power supply noise may not be fully cured with this filter. In such cases a shared battery should be avoided., Installation requires soldering in-series with the noisy power supply, as follows:, , Instructions:, Click Me!,
This compact supply filter helps clean up dirty DC power ...DPCAV
DIGITAL DC WATT METER / ANALYZER
| Instructions | Click Me! |
Features:, ,
The MX8120 is a handy digital meter for evaluating battery ...DPCAV
2.4GHZ PATCH ANTENNA, CIRCULAR POLARIZATION, +8DBI
| < 1.5 | 1 avg. |
Model:, , Data Sheet:, Click Me!,
This compact patch antenna is ideal for 2.4GHz RF applications. ...DPCAV
2.4GHZ PATCH ANTENNA, +8DBI
| < 1.5 | 1 avg. |
| RE09P-SM Data Sheet | Click |
| HG2409P-NF Data Sheet | Click |
Model:, SMA-Male, Model:, N-Female,
This compact patch antenna is ideal for 2.4GHz RF applications. ...DPCAV
GFORCE SENSOR, LOW G
| Resolution | approx. 0.05 G in each axis |
| Maximum | ±7 G in each axis |
| Power input (Standalone Mode) | 4V to 16V |
| Weight | approximately 4 grams (0.15 oz) |
| Dimensions | approximately 28x16x10 mm (1.1x0.62x0.4 Inch) |
| GFORCE-LOW Instruction Manual | Click Me! |
Specifications and Features:, ,
This tiny G-Force sensor is factory calibrated to measure up ...DPCAV
5.8GHZ PATCH ANTENNA, +8DBI
| < 1.5 | 1 avg. |
| Data Sheet | Click Me! |
Note: A coax cable (sold separately) is typically used to connect an RF device to this antenna. Due to coax's high RF losses at 5.8GHz operation, for best performance the cable should be as short as possible (no more than a few inches long)., Model:, ,
This broadband patch antenna is ideal for 5.8GHz RF applications. ...DPCAV
5.8GHZ PATCH ANTENNA, +11DBI
| < 2.0 | 1 avg. |
| Data Sheet | Not Available |
Model:, ,
This economy priced patch antenna is ideal for 5.8GHz FPV ...DPCAV
900MHZ PATCH ANTENNA, +8DBI GAIN
| < 1.5 | 1 avg. |
| Data Sheet | Click Me! |
Model:, ,
This compact patch antenna is ideal for 900MHz RF applications. ...DPCAV
1280MHZ BLUEBEAM ANTENNA SYSTEM, RHCP
| Center Frequency | 1280MHz, < 1.5 VSWR typical |
| RF Bandwidth | 180MHz (1180MHz-1360MHz, <2.0 VSWR) |
| Gain, 3-lobe | ~1.2dBiC |
| Gain, 4-lobe | ~0.9dBiC |
| Beamwidth | 360° omni |
| Polarization | RHCP |
| Multipath rejection | ~9db typical |
| RF connector | SMA Plug |
| Height | 2.8 inch |
| Width | 4.8 inch |
| Weight | 16g each |
| REFERENCE PLOTS | ANTENNA RF PATTERNS |
This 1280MHz antenna system contains TWO antennas:, One for the transmitter and one for the receiver., Manufacture:, Aerial Video Systems, Important: To ensure RF performance do NOT add paint or coat the element lobes (leave the factory applied finish as-is). The elements should not be allowed to rest against any structures. Do not bend or deform the elements., NOTE: We offer very low-loss extension cables that are specifically designed for the BlueBeam antenna system. Some FPV model installations may need an extension to ensure the antenna is away from nearby surfaces.,
The 1280MHz Bluebeam antenna system is circularly polarized (RHCP) and ...DPCAV
1080MHZ - 1200MHZ PATCH ANTENNA, +8DBI (L-COM RE1208P)
| < 1.5 | 1 avg. |
| Data Sheet | Click Me! |
Model:, ,
This compact patch antenna is ideal for 1.08GHz to 1.20GHz ...DPCAV
900MHZ A/V TRANSMITTER, 1000MW
| USA model has one RF channel | 910MHz (FCC imposed restriction). |
| USA Model Instruction Manual | Click Me! |
| Non-USA Instruction Manual | Click Me! |
Non-USA model has four RF channels:, 910MHz, 980MHz, 1010MHz, 1040MHz, Important note: The DC input connector is a 2.1mm barrel style connector that is center (+) positive. Reversed voltages will damage the receiver., Notice: Due to its high RF power, using the TX9-1000 in the USA and other countries will require an amateur/ham radio license (some countries may forbid its use). It is your responsibility to ensure that its use meets the requirements imposed by your government’s RF spectrum regulations. Do not purchase this product if you are unsure of the government requirements or are not able to comply with them., We offer 900MHz A/V receivers that work great with this transmitter. So if you don't already have a compatible receiver then be sure to check them out:click here,
This 900MHz / 1 Watt (1000mW) wireless A/V transmitter is ...DPCAV
DIGITAL OSCILLOSCOPE, 1MHZ
| Note | This is the improved hardware model and it is FACTORY ASSEMBLED (it is not a kit). |
| Source Coupling | DC/AC. |
| Storage Mode | Hold/run, BMP export. |
| Sample Waveform | Click Me! |
| 500Hz test signal | Click Me! |
| Frequency Measurement | Click Me! |
| Sawtooth Waveform | Click Me! |
| FFT 100KHz Measurement | Click Me! |
| FFT Demo Video | Click Me! |
| Instruction Manual | Click Me! |
| Manufacture's Web Site | Click Me! |
New and Improved Digital Oscilloscope:, Now with higher accuracy, FFT frequency domain display, external trigger I/O, and many other new features. It has 1MHz analog bandwidth, up to 2MSa/s real-time sampling, and digital storage for freezing waveforms. This has to be the best value Digital Oscilloscope on the planet!, Features:, Max sample rate - 2M/s，8 bits., Related photos:, , Useful Links:,
Included is a universal 100-240VAC 50/60Hz wall adapter with North ...DPCAV
WIRELESS VIDEO TRANSMITTER & OSD, FPV DEAL
| Item A | EagleTree eLogger V4 with 100 Amp sensor. |
| Item B | USB cable for eLogger firmware updates. |
| Item C | Eagle Tree OSD Pro Video Expander module. |
| Item D | GPS extension cable for kits shipped before June-2010. |
| Item E | eLogger GPS-V4 Expander module. |
| Item F | Eagle Tree OSD Pro cable Kit. |
| Item H | DPC-420A 420 line CCD color camera. |
| Item I | DPC-420A/480A camera interconnect cable. |
| Item J | TX9-500 900MHz / 500mW transmitter. |
| Item K | Dipole Antenna, +3dBi omni-directional. |
| Item L | Deluxe A/V cable for TX9-500 transmitter. |
| Item M | Male-male video adapter cable, |
This wireless OSD system will transmit graphic data and voice announcements that report a variety of alarms and data, including: voltage, current, mAH, Watts, Home Arrow, Return to Home (RTH / RTL), RADAR, altitude, course (travel direction), ground speed, longitude, latitude, and navigation waypoints. You can expand this system even further by using the low cost eLogger accessories, such as these:Click Me!, Here's a screen shot that shows some of the information that can be shown (temperature and RPM data requires optional accessories):, , All the data parameters that are supported by the eLogger can be displayed on the video display. Here are some examples:, , Notice: Due to the 900MHz transmitter's high RF power, using it in the USA and other countries will require an amateur/ham radio license (some countries may forbid its use). It is your responsibility to ensure that its use meets the requirements of your government’s RF spectrum regulations. Do not purchase this product if you are unsure of the government requirements or are not able to comply with them., . We have other battery choices so that you can select the best one for your application. More choices:Click Me, (3) The 900MHz A/V receiver is not included, but we offer fully compatible models that work great with this special package. Please look here to purchase them:click here, The video format is available in NTSC or PAL. If you are unsure which to choose then please consult this list:TV Video Standards., ,
Ok, so you've decided that you need the EagleTree OSD ...DPCAV
ELOGGER BRUSHLESS RPM SENSOR
| RPM-BRS-V2 Instruction Manual | Click Me! |
DPCAV
ELOGGER TEMPERATURE LOOP SENSOR
,
The Temperature Loop sensor measures temperatures up to 420°F (215°C). ...